British General IP55 Enclosure Grey 150 x 53 x 85mm Product Code: 35121

IP55. Weatherproof and dust-tight polycarbonate enclosure. Can be mounted horizontally or vertically.


  • IP55 Protection
  • 6 x M20 Cut-Outs
  • 1 x M25 Rear Cut-Out With Sealant Ring


W x D x H: 150 x 53 x 85mm. 6 x M20 cut-outs (2 top, 2 bottom and 1 on each side). EN 60670.
Additional Information
Technical Specification
  • Brand : British General
  • Product Height : 85 mm
  • Product Type : IP55 Enclosure
  • IP Rating : IP55
  • Total Product Weight : 0.18 kg
  • Product Width : 150 mm
  • Colour : Grey
  • Product Depth : 53 mm
  • Pack Size : 1
  • Manufacturer Guarantee : 1 Year Guarantee
  • Pieces in Pack/Case : 1
  • CE Standard (Tested to EN...) : EN 60670.
Product Contents
Delivery & Returns


Standard delivery: €15

Free delivery on all orders over €70.00

Click here to see information on our delivery charges and times



Hopefully you won't need to return an item, however, if you do, it is our aim to make this as simple as possible. By following the guidance below you can help us to help you when a product is not what you expected, or is faulty. Your statutory rights are not affected by this guidance.


Click here to see information on returns and cancellation

€5.55 Incl. 20% VAT

Add to Wishlist

More Items to Consider

Loading... Loading...
British General IP55 Enclosure Grey 150 x 53 x 85mm is rated 3.5 out of 5 by 51.
Rated 4 out of 5 by from Ip55 Bought as an enclosure for outdoor lights using a WiFi switch. 20mm holes needed drilling out as not knock-out. Front cover is held on with 4x screws fitted with a flat rubber gasket. Hence Ip55 not Ip65. Done the job .
Date published: 2019-08-26
Rated 3 out of 5 by from Cheap, but does the job The supplied screws were pretty poor, and one sheared off in the box when being tightened to get a good seal on the sealant ring! Also, used this box for outside wiring so wanted a tight fit for the cables, but didn't realise I would need gland/conduit entries to keep the seal waterproof. Instead, I just drilled a smaller hole in the plastic, same size as the cables.
Date published: 2019-05-07
Rated 3 out of 5 by from Not impressed After wiring up I put the lid on and three of the screws snapped off due to the poor quality of the screws. Had to disassemble and take the box back to get a replacement thus wasting a lot of time When reassembling I had to use my good quality self tappers In If descent screws had been supplied I would of given 5 stars
Date published: 2019-05-03
Rated 1 out of 5 by from Poor Quality Screws Upon recieving this product I was immediatley impressed as it looked quite good quality for the price. It wasn't until I fixed this unit to the wall and tried to secure the lid on then that the lack of quality showed. It was difficult to screw the screws in and if you over tightened slightly the screws snapped. I thought this might me been a bit too rough but it then happened on the smaller junction box I purchased.
Date published: 2019-03-10
Rated 2 out of 5 by from Poor quality screws The screws for the lid are of poor quality, two of them the screwheads sheared off when tightening. Also the cable entry holes have to be drilled rather than snapping out like on more expensive products. In summary, yes it's cheap, but then so is sawing your own leg off....
Date published: 2019-03-01
Rated 2 out of 5 by from frustrating Used this to gland off a swa cable to my garden shed. the box itself seems good, however, the screws supplied are rubbish. Using the correct screwdriver, the head of the screws chew up easily. One of the screws head snapped off completely even though it was not tightened right up. I ended up removing the shank of the screw with a pair of pliers. I had to replace all the screws with screws of a much better quality
Date published: 2019-02-01
Rated 3 out of 5 by from Good Box poor screws The Box is fine. The screws holding the lid are very poor quality. One snapped off when fitting.
Date published: 2019-01-30
Rated 4 out of 5 by from Take care with the screws A good quality box, let down by appalling quality screws. Two of the four sheared off before the lid was tight. I've used these boxes before and had the same screw issue. My advice is run the screws in and out before doing anything else. If they are going to give you problems at least you'll know before you commit the box to the job. Or just use your own decent self tappers.
Date published: 2019-01-01
  • y_2019, m_9, d_19, h_7
  • bvseo_bulk, prod_bvrr, vn_bulk_2.0.13
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_51
  • loc_en_GB, sid_35121, prod, sort_[SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix-ie